Metallor Push Pull Pot DPDT Switched Guitar Bass Potentiometer Audio Volume Tone Split Shaft Control Switch 18mm with Nuts and Washers Guitar Parts Replacement (A250K)

Feature

A250 kOhm logarithmic taper potentiometer with Double Pole Double Throw ( DPDT on-on ) push / pull switch. 6mm splined shaft to accept standard push on control knobs.
This switched pot is suited to being used in place of the standard tone pot, although it is personal choice whether you use these taper pots for volume or tone, on a single coil equipped guitar to provide tonal switching options. Typical uses include phase reversal, tone capacitor switching, tone bypass etc.
Shaft length: Approx. 18mm shaft diameter: Approx. 6mm Whole length: Approx. 45mm Base diameter: Approx. 22mm
Full size; Coarse knurled split shaft fits most control knobs
Package included: 1pc potentiometer, Supplied with 2 x mounting nuts and 1 washer.

Description

250K VS 500K

Generally, 500K-ohm pots are used with humbuckers and 250Ks are used with single-coil pickups. You can use any value you like, but a 250K will give a slightly warmer tone than a 500K pot. The 250K pot bleeds off some of the high frequencies to ground. A 1 Meg-ohm pot bleeds off even less than a 500K pot, so if you want to hear your guitar "wide open" you may want to try one.

Product Description:

For bass guitar mainly
Push pull switch pots
A250k resistance
A type tone style
Approx. 18mm long shaft
Full resistance: 250k ohm
Shaft Diameter: Approx. 6mm
Whole length: Approx. 45mm
Base size: Approx. 22mm
Knurled and split shaft

Package Included:

1pc guitar bass pot, comes with nut and washer